Monday, July 11, 2016
Freemason
Yesterday I took the Diamondback out to Salmon Falls. The last time I rode there I found the terrain to be a bit rough, so I figured it would be a good proving ground for the 27-plus bike.
The bike is still stock except for new grips, which were too thin and hard for my liking. I also converted the tires to tubeless. The rims were already taped, so it was simply a matter of removing the tubes, inserting the valve and adding some sealant. The tires aired right up. By far my easiest conversion to date. The stock tubes were very thick and heavy, and removing them saved 1.5 pounds. Nice.
Since I bottomed out once on the last ride on a much mellower trail, I ran a bit more air pressure due to the rocky nature of Salmon Falls. Right off the bat I noticed a huge improvement in the way the bike felt even with more air pressure. Tubeless tires simply perform better. Losing 1.5 pounds of rotating weight certainly doesn't hurt, either.
I am having a hard time finding any negatives with the 27-plus platform. It might be a little slower than a 29er in some situations, but I can't even say that for sure. To truly compare I would need to have two bikes of equal quality, and the Mason Trail doesn't stack up to my other bikes from that standpoint. Still, it holds its own.
The first part of the ride is mostly flat trail cut into a steep hillside, with plenty of rocks. It's my least favorite part of the ride, but the fat tires made it much better. Almost fun. On the very first downhill I opened it up and let it fly. I can honestly say I have never gone faster on that section. The slack angles and big tires changed my normal hardtail approach from "picking good lines" to simply plowing over everything. It's a different way to ride, and not without merit.
After some fun up-and-down singletrack comes the grind up Flagstaff, which climbs 675 feet in 1.6 miles. Years ago it was a fast fire road downhill, but today it better resembles a rocky, rutted, overgrown creek bed. I spent much of the first half in the 30x36 gear, but had to drop into my lowest gear (30x40) a couple times. I think for the most part I can get up any climb with the single ring setup, especially with the crazy traction of the plus tires.
The second half isn't as steep or rocky. The view from near the top:
The last steep stretch:
After a paved downhill is the back section, which is a fairly smooth stretch except for all the gopher/squirrel holes. If you've ever ridden a squirrel-holed trail, you know it can be a speed sapping experience. It's here where I noticed the flotation of the tires the most.
As I was motoring along, I caught up to a guy on a carbon fiber Stumpjumper FSR. He looked down at my bike, and the look on his face said, "Did this dude just catch me on that Walmart bike?" Yes. Yes, he most certainly did.
I passed him and he jumped on my wheel for a quarter mile or so. On a slight rise I hit the gas and I heard him gurgle something to the effect of "ughndwuh" and drop anchor. Bye now!
After that you enter a section with twisty, flowing trail. It's slightly downhill and fast. I had a blast testing the limits of traction in the corners.
With two rides now on vastly different terrain, I will say this: I think the 27-plus platform is the future. It's that good. You retain the rollover of the 29er diameter, have similar flotation to the 29-plus tire, yet eliminate some of the 29-plus heft I experience with the Krampus.
The ability to have one bike that can run a fast wheelset (29er) and a bomber wheelset (27-plus) is pretty cool, too. And for the most part you don't lose a lot when running the 27-plus wheels anyway. I haven't tried a 27-plus full suspension yet, but the three-inch tires definitely negate many of the drawbacks of a hardtail bike. It's just enough float to take the sting out of the trail.
More to come. Later.
Wednesday, July 06, 2016
Commute
I rolled down the driveway at about 4:15, lights blazing. I am running 750 lumens on my helmet and 700 on the bars, which is plenty as long as you keep it under 60 miles per hour or so.
I hit the first stretch of dirt in about 30 minutes, dodging the bunnies and hares frantically zig-zagging away from the light-emitting monster crunching though the night. I am not exaggerating when I say I saw at least 50 of them. They were everywhere. It was like a video game.
On the next trail section I got into a groove and only made one small mistake. I was going fast, making great time and having fun.
I hit the Brown's Ravine trail at about the hour mark and it was still dark in the woods. When I emerged only a few miles later the sky was just starting to brighten:
Most of the rest was on the bike trail, and I was OK until about mile 30. At that point I wanted off the bike, and my speed slowed a bit.
I rolled into work with a time of 2:45, about 15 minutes slower than I used to do it. Getting old.
Later.
Saturday, July 02, 2016
Stonemason
I went out to do a loop in Granite Bay, which is my typical testing ground for new bikes. I parked in El Dorado Hills and rode the Brown's Ravine trail as a connector.
The terrain is mostly rolling with a handful of steep climbs. Soil conditions are sand and silt over hardpack for the most part.
My expectations for this bike were somewhat low considering my experience with the Krampus, a 29 plus bike that is a pondering beast. I figured the Mason would be a blast on downhills and below average everywhere else. Still, I bought it hoping for more.
Goofing around the driveway last night with flat pedals, I thought maybe my assumptions were wrong. It sure felt quicker and more agile than the Krampus, even with the seemingly ridiculous 66-degree head tube angle.
This morning, once my familiar Time pedals were installed and the seat height dialed in, I immediately felt comfortable. Again, after looking at the geometry chart and seeing the straight post and short stem, I assumed a cramped, upright position. Nope. I was quite comfortable in a familiar seated position. Weird.
On the trail it felt like a bike. I say this as a compliment. Once I hit the dirt I really forgot I was on a brand new bike. There was no learning curve or adjustment period. Hills came and I climbed them. Turns came and I carved them. Descents came and I bombed them. After about 30 minutes, I thought to myself, This is what we should have been riding years ago.
As the ride progressed, and I pushed the bike harder in the turns, I noticed quite a bit of tire squirm. The rims are only 30mm wide, and I really think 40mm should be the bare minimum for a plus sized tire. At the pressure I was running, which provided incredible traction and flotation, the sidewalls were not getting enough support in turns. This would really be my only major complaint with the component choices. In my own experiments with rim and tire width, you simply must use a wide rim to get them most performance out of wide tires.
Everything else worked OK considering the price point. Shifting was perfect. The brakes leave a little to be desired, but hopefully they will improve after more break-in time. The fork is adequate.
It's only been one ride, and I just wanted to get some quick thoughts down, but so far so good. I like it.
Later.
Friday, July 01, 2016
Masonite
There are a number of technologies I am using for the first time. The wheels are 27 Plus with 110x15 Boost spacing:
In the rear a 148x12 Boost thru-axle:
Boost 148 spacing on the cranks, too, of course:
And, believe it or not, my first hydraulic brakes:
This bike also has a 66 degree head angle, by far the slackest bike I have ever owned. Paired with fairly short chainstays and a long top tube, it will be interesting to see how it rides. The plan is to put it through its paces tomorrow.
Later.
Wednesday, June 29, 2016
Tuesday, June 28, 2016
Riding Season
Sunday, June 05, 2016
Retainer
About three weeks ago I decided to tackle a fairly large project. Ever since we made the made the decision to remove the grass, I knew the stairs leading to the pool would need some sort of solution for the elevation change. You can grow grass on a steep slope, but the replacement gravel would never stay in place. It was time for a wall.
I decided on a square area and a two-sided wall. In the middle I wanted a blue palm tree as a centerpiece. Time to dig.
I carved out the basic outline of what I wanted.
Getting the first layer right is 90% of the work.
After that you just start stacking.
And stacking.
Nailed the height.
Then you backfill.
Then the long process of laying plastic and moving tons (literally) of gravel.
A Mexican Blue Palm.
Mostly done.
I am pretty happy with the results.
The property certainly looked better with all the grass we used to have, but ultimately the water bill and the harassment from El Dorado County forced an alternative. It's also very difficult to maintain grass up here in the foothills. There is a constant battle with weeds, moles, voles, raccoons, sprinklers, mowing, edging, etc. Even what little we have left in back and on the side is a hassle.
Anyway, another project down. Time for a Sunday night beer.
Later.
